Norfloxacin Tablets

General Notices

Action and use

Fluoroquinolone antibacterial.

Definition

Norfloxacin Tablets contain Norfloxacin.

The tablets comply with the requirements stated under Tablets and with the following requirements.

Content of norfloxacin, C16H18FN3O3

95.0 to 105.0% of the stated amount.

Identification

A. Carry out the method for thin-layer chromatography, Appendix III A, using the following solutions, protected from light.
(1) Add 2 mL of water to a quantity of whole tablets containing 0.4 g of Norfloxacin and disperse with the aid of ultrasound. Add 100 mL of a solution containing 50 volumes of dichloromethane and 50 volumes of a solution prepared by adding 9 mL of hydrochloric acid to 1000 mL of methanol. Mix with the aid of ultrasound until a uniform suspension is produced, add sufficient of the same solvent mixture to produce 200 mL and centrifuge 25 mL of the final solution.
(2) Dissolve, with the aid of ultrasound, 50 mg of norfloxacin BPCRS in 15 mL of a solution containing 50 volumes of dichloromethane and 50 volumes of a solution prepared by adding 9 mL of hydrochloric acid to 1000 mL of methanol; add sufficient of the same solvent mixture to produce 25 mL.
chromatographic conditions
(a) Use a silica gel GF254 precoated plate which has been previously washed with methanol and allowed to dry in air (Analtech plates are suitable).
(b) Use the mobile phase as described below.
(c) Apply 50 µL of each solution.
(d) Develop the plate to 15 cm.
(e) After removal of the plate, allow it to dry in air and examine under ultraviolet light (254 nm and 365 nm).
mobile phase

8 volumes of water, 14 volumes of diethylamine, 20 volumes of toluene, 40 volumes of chloroform and 40 volumes of methanol.

confirmation

By each method of visualisation, the principal spot in the chromatogram obtained with solution (1) corresponds in position, colour and size to that in the chromatogram obtained with solution (2).

B. In the Assay, the principal peak in the chromatogram obtained with solution (1) has the same retention time as the principal peak in the chromatogram obtained with solution (2).

Tests

Dissolution

Carry out the procedure protected from light. Comply with the requirements for Monographs of the British Pharmacopoeia in the dissolution test for tablets and capsules, Appendix XII B1.

test conditions
(a) Use Apparatus 2, rotating the paddle at 50 revolutions per minute.
(b) Use 750 mL of an acetate buffer solution prepared in the following manner, at a temperature of 37°, as the medium. Add 14.3 mL of glacial acetic acid to 4500 mL of water and mix. Add slowly, with stirring, 2.5 mL of a 50% w/v solution of sodium hydroxide and add sufficient water to produce 5000 mL. If necessary, adjust the pH to 4.0 with glacial acetic acid or a 50% w/v solution of sodium hydroxide.
procedure
(1) After 30 minutes withdraw a 20 mL sample of the medium, filter and dilute the filtrate with sufficient of the dissolution medium to give a solution expected to contain about 0.0016% w/v of Norfloxacin. Measure the absorbance of this solution, Appendix II B, at 313 nm using dissolution medium in the reference cell.
(2) Measure the absorbance of a 0.0016% w/v solution of norfloxacin BPCRS in the dissolution medium using dissolution medium in the reference cell.
determination of content

Calculate the total content of norfloxacin, C16H18FN3O3, in the medium from the absorbances obtained and using the declared content of C16H18FN3O3 in norfloxacin BPCRS.

limits

The amount of norfloxacin released is not less than 85% of the stated amount.

Assay

Weigh and powder 20 tablets. Carry out the method for liquid chromatography, Appendix III D, protected from light, using the following solutions.

(1) Add 80 mL of the mobile phase to a quantity of the powdered tablets containing 0.1 g of Norfloxacin and mix with the aid of ultrasound for at least 5 minutes. Add sufficient of the mobile phase to produce 200 mL, mix and dilute 10 volumes of this solution to 25 volumes with the mobile phase.
(2) 0.02% w/v of norfloxacin BPCRS in the mobile phase.
chromatographic conditions
(a) Use a stainless steel column (30 cm × 3.9 mm) packed with end-capped octadecylsilyl silica gel for chromatography (10 µm) (Waters µBondapak C18 is suitable).
(b) Use isocratic elution and the mobile phase described below.
(c) Use a flow rate of 2 mL per minute.
(d) Use a column temperature of 40°.
(e) Use a detection wavelength of 275 nm.
(f) Inject 10 µL of each solution.
mobile phase

150 volumes of acetonitrile and 850 volumes of 0.1% v/v orthophosphoric acid.

Precondition the column using 0.01m anhydrous sodium dihydrogen orthophosphate, adjusted to pH 4.0 with orthophosphoric acid, at a flow rate of 0.5 mL per minute for 8 hours. Equilibrate the column with the mobile phase for about 30 minutes before starting the chromatography.

When the chromatograms are recorded under the prescribed conditions, the retention time of norfloxacin is about 5 minutes.

system suitability

The Assay is not valid unless the symmetry factor of the principal peak in the chromatogram obtained with solution (2) is less than 2.0.

Inject solution (2) six times. The Assay is not valid unless the relative standard deviation of the area of the principal peak is at most 2.0%.

determination of content

Calculate the content of C16H18FN3O3 in the tablets using the declared content of C16H18FN3O3 in norfloxacin BPCRS.

Storage

Norfloxacin Tablets should be protected from light and moisture.